I would like advice on how to decrease the trigger pull on my Rem. 7600???

[Bulletswapper]

I know how to remove the "trigger group". I have factory instructions however these instructions say factory authorized probably based on liability?????

I would like to either file the spring 1/2 turn at a time until I achieve a desired pull wt. Helpful advise and experience is welcome.

Please post your experinces in detail.
THANKS YOU
BULLETSWAPPER

[Bulletswapper]

As of right now 529 views and no responses. ?????? Doesn't any one know how to????

[cowboybart]

On a 760 - just push out the pins, with the hammer in the cocked position. I would stone the trigger hook and sear before removing spring metal. Yours is newer than mine and that means poor machining and finish work to make the lawyers happy.

[Rapidrob]

Your bet bet would be to contact Wolff Springs and see if they have a lighter "kit". Cutting a spring could cause a too weak spring,or excessive play that could cause an unsafe trigger or accidental discharge.
An aftermarket rigger would be a better way to go.
I've been a hobby gunsmith for over 50 years and triggers,other than polishing mating surfaces, should not be modified in any manner unless you are 100% sure of what you are doing and the factory authorizes these modifications.